🛜C5Deauther

A tool that deauth 2.4GHz and 5GHz Wi-Fi networks via ESP32C5 on serial console.

⚠️WARNING

• This project is for educational purpose only.
• Don't use in any illegal way.

✨Features

• Minimal Setup.
• Simply controlled by Serial Console.

📦Requirements

• 1 Waveshare ESP32-C5 N32R8 Development Board
• 1 Type-C USB Cable with data transfer support

Note

Use those varient which contain atleast 4MB flash memory.

🔧Install

1. Download .bin file from here.
2. Download esptool.exe from here.
3. Connect board by UART port to the computer.
4. Put both files in a folder.
5. Open CMD in that folder.
6. Type the following command to check COM port of that board:

mode

7. Type the following command to flash .bin file on the board:

esptool.exe --chip esp32c5 --baud 460800 --port COMx write_flash 0x0000 C5Deauther.bin

9. Replace x after the COM with the number show by mode command.
10. Hit Enter.
    • Wait for sometimes to flash.
11. Done!

📟Using Serial Console

1. Open Serial Console by click here.
2. Unplug and plug again board by UART port.
3. Click on Connect button.
   • It show a pop-up window and it has connect devices with port number.
   • Select the correct device.
   • Click on Connect button in pop-up window.
4. When it shows Connected! Go On! then your ESP32 Development Board is ready to use.
5. Press and release EN or RST button.
6. Type help to get available commands.